[. . . ] Using the Chimes Safely Preventing Injuries —Make sure that all precautions described below are obeyed— About the Icons Icons are used in this section to promote the safe use of this product, and to prevent you and others from harm and property damage. Please fully understand the meaning of the icons before reading the manual. This icon indicates special instructions that should be strictly followed. Warning Disregard of the warnings with this mark or misuse may result in death or personal injury. [. . . ] After moving the instrument, check and make sure all bolts, parts, etc. Please read this owner’s manual carefully, and truly enjoy this instrument for years to come. Before you use 1 Never use a metal type hammer or mallets to strike the sound column with. 3 When assembling the stand, make sure each part is firmly attached, and there is no twisting or disfigurement in the frame. Moving the adjuster may result in the damper not functioning properly. Damper Adjuster 6 When playing the chime, make sure the caster brakes are firmly set and the chime stand does not move about. Head Plug Sound Column 8 Do not keep the chime in a place where high temperatures and high humidity are present. Be careful when transporting 1 When transporting or moving the instrument, do not subject it to strong shocks. 2 The sound column’s pitch and/or tone may change if the columns are scratched or bent. 3 When the instrument is to be transported over long distances, especially by vehicle, do so with the sound columns removed from the stand. The shape of the stand may change and the column’s wire/strings may be cut if the columns are not removed. 4 When attaching or removing the sound columns, do so in a place where there is sufficient room so that the columns do not come into contact with other objects. 5 After the sound columns are removed, wrap them in a soft cloth, etc. 7 CH-500/CHS-520 ASSEMBLY PROCEDURE 1 Insert the side columns into the base. At this time, make sure that the damper rest, attached at the center of the column, and the short section of the column is positioned upright. 3 Remove the damper stay, attached to the bottom of the damper, loosen the wing bolt on the damper stay, and attach the stay to the pedal hook. The pedal’s position can be controlled by adjusting the length of the pedal stay with its two wing bolts. At this time, tighten the upper wing bolt first, then go on to tighten the lower bolt. Adjust the pedal position so that the pedal stops slightly above the floor when fully depressed. Side Column Short Section Damper Rest Damper Stay Long Section Base Pedal Hook Base 4 2 Slide the hanger onto the side columns. [. . . ] ) Side Column 3 Fit the guide board onto the side columns and lower the guide board until it rests on the board rest. Guide Board Board Rest Base Hanger Bar Attachment Fixing Hole Base Bar Block Bolt 4 Attach the hanger bar on the top of the side columns and secure with the wing bolts. At this time, also tighten the wing bolts on the side column and base. Hanger Bar 2 Side Column After tightening the block bolt, re-insert the side column into the base with making sure that the side column’s hanger attachment positioned upright. [. . . ]